: For niche software, community forums or user groups can be a great resource. Users often share links to legitimate sources or provide advice on software setup. Always save your current $$ GRBL settings before
I thought I would add this just in case someone runs into this problem WITHOUT having a fuse in the DIA location.
The DTAC solution # is 71449 dated 12-22-2010.
Solution Summary: 00/10/20 W/T tractor goes into diagnostic mode on its own.
Complaint or Symptom: Tractor goes into Diagnostic mode while operating in the field. Corner post display stops showing engine RPM and displays DIA while engine is running. Tractor can be shut off and restarted to return to normal operation. Circuit 312 acquires enough voltage from other circuits to place controller into diagnostic mode without a fuse in diagnostic mode position F10.
Solution: Insert a male spade terminal into diagnostic fuse F10 for circuit 312 (non-powered side). Connect the other end of this wire to a ground terminal in the power strip. This prevents circuit 312 from causing controllers to go into diagnostic mode without a fuse installed in position F10.
CAUTION: Make certain to use a voltmeter to identify which side of fuse holder F10 does not have 12 volts applied to it. Non-powered side of fuse F10 is connected to circuit 312.
I had a 8410 a couple of years ago with this problem and a ground wire cured it.
Disabled transmission on jd 8310
