Mks Gen V1.4 Klipper «macOS FULL»

Remember to check your endstop logic. If your endstops are "Normally Open," you may need to add a ! before the pin name (e.g., ^!ar3 ) to invert the signal. Troubleshooting Common Issues Connection Errors

What are you upgrading (Ender 3, CR-10, custom)? Which stepper drivers are you using (TMC2209, A4988, etc.)? Do you have a Bed Leveling sensor like a BLTouch? mks gen v1.4 klipper

This board has limited flash and RAM, but Klipper's firmware ( klipper.bin ) is tiny (~32KB). This is completely fine. Remember to check your endstop logic

[tmc2208 stepper_x] # Don't use tmc2208 if using A4988 – just omit this section # Actually: For A4988, remove any [tmc...] section. mks gen v1.4 klipper

SSH into your Pi:

Happy printing.